Hot-Water Tubes

[M-NB]
[materials] PA12
[specification temperature range] -15 to 90 ° C
[color] blue, milky white

[M-WE]
[materials] polyolefin system
[specification temperature range] 0 to 99 ° C (water) -30 to 30 99 ° C (air)
[color] milky white

[M-SET]
[materials] fluorocarbon resin
[specification temperature range]-65 to 200 ° C
[color] black , transparent

[M-SFT]
[materials] fluorocarbon resin
[specification temperature range]-65 to 260 ° C
[color] transparent

● Before use,
select one tube according to the temperature of cooling water Please give me.
2 Tubes can be used with both cooling water and oil. (※ M-WE is only water)
3 When inserting a tube into a mold cooling one-touch joint or tightening joint, cut both ends of the tube at a right angle before use.
Be careful when the end face of the tube is cut diagonally, as it may cause dropout of the tube or water leakage trouble.
4 Attach the hot water tube to the one-touch fitting in combination with the dedicated insert sleeve .
Please note that using a hot water tube without an insert sleeve may cause the tube to come off or leak problems.
(5) The breaking pressure of the hot water tube (M-SFT) decreases as the temperature rises. Therefore, when using at high temperatures, check the breaking pressure table in [Standards / Delivery tab] before using.
6 Tightening Fittings StraightWhen reattaching the tube to the tightening joint L-shape , cut the part once attached and then attach it.
Keep in mind that it may cause drop-off of the tube and water leakage if it is installed as it is.