Simple Joint Kit for Aluminum Frame Blind Joints

Dimensional Drawing of Blind Joint Parts

HUJ(Simple Blind Joint Parts Kit)

① Simple Blind Joint Parts body (set screw included)

②Special bolt

Frame A and Frame B are fastened together when the set screw presses against the head of the dedicated bolt.

Specification Table of Blind Joint Parts

How to Use of Blind Joint Parts

HFS6-3030-1000-LTP

Enlarged view

Insert it into the groove of frame Ⓑ .

HFS6-3030-1000

Tighten the set screw on the simple Blind Joint Parts body with a hex wrench to complete the installation.

■ Simple Blind Joint Parts connection (connects at the corners or in the middle of the frame)

procedure	Side View	Floor plan	<Example for HFS6-6060> ・Four simple Blind Joint Parts are used <Example 1 for HFS6-3090> ・Three simple Blind Joint Parts are used <Example 2 for HFS6-3090> ・In this case, two simple Blind Joint Parts are used.
1	HUJ6
	Pass the special bolt 2 through the simple Blind Joint Parts body 1 and attach it to the tapped hole in the frame Ⓐ.
2	If the bolts are tightened too much, they will not fit into the grooves of frame B, so be sure to leave some play.	When the bolt is fully inserted, loosen it so that the bolt head turns half a turn, leaving some play in the X section.
3
4

■ Order example

When fitting the panel into the groove of the frame, a notch may be required depending on the direction in which the simple Blind Joint Parts is installed.

Example of no need for panel cutout

Example of required panel cutout

Product Comparison Information of Blind Joint Parts

If using a regular bracket would cause interference with the surrounding area, we recommend a Blind Joint Parts connection. Please refer to the table below and check the detailed specifications on the product page.

Product name	Simple Blind Joint Parts	Single Blind Joint Parts	Tapping Blind Joint Parts	Screw Blind Joint Parts	Center Blind Joint Parts	Post-insertion double Blind Joint Parts	First-in double Blind Joint Parts	Parallel Blind Joint Parts
Product Photos
Installation Diagram
Blind Joint Parts Material	S45C/SCM435	Iron or SUS304	SWCH-18A	Iron or SUS304	SCS13	Equivalent to SCS13/SUS304	SUS316 equivalent / SUS304	SCS13/SUS304
Blind Joint Parts Features	No additional machining of wrench holes is required, and fastening can be done in one place.	Since the additional D hole does not penetrate all the way to the flat surface, this is a Blind Joint Parts with particularly excellent aesthetics.	No additional tapping holes are required. This is the most inexpensive Blind Joint Parts.	The plate allows for reliable and inexpensive connection.	This is the most common Blind Joint Parts that can be used with a wide range of aluminium frames.	Stable fastening is possible from two points. This is the strongest fastening possible with Blind Joint Parts.	This Blind Joint Parts can be used for a variety of purposes, such as extending frames or attaching to plates.	The frames can be connected side-by-side.
6 Series Product Page	Viewing	Product page	Product page	Product page	Product page	Product page	Product page	Product page

6 Series Aluminum Frame Related Parts of Blind Joint Parts

■6 Series (groove width 8mm)

Product name	Aluminum frame	Blind Joint Parts	nut	Frame cap	Groove cover
photograph
Product page	Here	Here	Here	Here	Here

Example