Torx Bit for 6 Series Aluminum Frame Blind Joints

Dimensional Drawing of Blind Joint Parts

Blind Joint Parts HTJXL

Specification Table of Blind Joint Parts

How to connect of Blind Joint Parts

*Torx bits are used to fasten tapping Blind Joint Parts.
6 series tapping Blind Joint Parts: HTJ6
8 series tapping Blind Joint Parts: HTJ8

Tapping joint connection method (frame can be fastened without additional tapping)

procedure	1	2	3
explanation	Temporarily fasten the tapping Blind Joint Parts to the end of the frame. (See the appropriate tightening torque above.)	Insert the head of the tapping Blind Joint Parts into the groove of frame B and slide it to the underside of A.	Insert the Torx bit through the wrench hole and tighten with an electric screwdriver.
Tapping Blind Joint Parts	* No tap holes are required.	Side View

The tapping Blind Joint Parts is used to fasten the screws while tapping.
It requires a lot of force because the aluminum is cut while it is inserted and fastened. A Torx bit is used instead of an electric drill bit to fasten the screws.
In addition, to fasten two aluminum frames in an L shape, a wrench hole is required in one of the aluminum frames. It
can also be fastened in a T shape by specifying a wrench hole in a specified position.

Product Comparison Information of Blind Joint Parts

■6 Series Blind Joint Parts

Product name	Tapping Blind Joint Parts	Screw Blind Joint Parts	Simple Blind Joint Parts	Single Blind Joint Parts	Center Blind Joint Parts	Post-insertion double Blind Joint Parts	First-in double Blind Joint Parts	Parallel Blind Joint Parts
Product Photos
Installation Diagram
Blind Joint Parts Material	SWCH-18A	Iron or SUS304	S45C/SCM435	Iron or SUS304	SCS13	Equivalent to SCS13/SUS304	SUS316 equivalent / SUS304	SCS13/SUS304
Blind Joint Parts Features	No additional tapping is required. Wrench holes are drilled into the mating frame. This is the most inexpensive Blind Joint Parts.	The plate allows for reliable and inexpensive connection.	No additional machining of wrench holes is required, and fastening can be done in one place.	Since the additional D hole does not penetrate all the way to the flat surface, this is a Blind Joint Parts with particularly excellent aesthetics.	This is the most common Blind Joint Parts that can be used with a wide range of aluminium frames.	Stable fastening is possible from two points. This is the strongest fastening possible with blind joints.	This Blind Joint Parts can be used for a variety of purposes, such as extending frames or attaching to plates.	The frames can be connected side-by-side.
6 Series Product Page	Product page	Product page	Product page	Product page	Product page	Product page	Product page	Product page

6 Series Related Products of Blind Joint Parts

■6 Series (groove width 8mm)

Product name	Aluminum frame	Blind Joint Parts	Frame cap	Groove cover	nut
photograph
Product page	Here	Here	Here	Here	Here