[Clean & Pack]Plastic Pan Head Screws - With Flathead Slot, Inch Size, PEEK

Brand :

MISUMI

Caution

There is no discoloration or dimensional change due to cleaning.

Product Description

Two types of cleaning methods are available: "degreasing" and "precision cleaning." They can be ordered from one piece with the standard part number.
This eliminates the need for customer cleaning or outsourced cleaning, reducing the amount of time and effort required.

Cleaning Method	Product Part Number	Packaging Type	Effects Compared to Uncleaned Product	Environment (Standard)	Use Case
Degreasing	SL-□□	Anti-rust packing	Removal of organic stains	General environment	Regular assembly process
					Post battery assembly process
Precision cleaning	SH-□□	Degassing double packing	Removal of organic stains Removal of contamination and dusts	Clean environment (Class 10 to 1,000)	Battery assembly process
					LCD-related post assembly process
					In-vehicle camera assembly process

Inch type plastic screw
· Material: Plastic (PEEK)
· Shape: Standard (round), pan head, slotted

Type	[M] Material	Cleaning Method
Type	[M] Material	Cleaning Method	Cleaning Environment	Packaging Type	Packing Environment
SL-PEKMPI	PEEK (Polyetheretherketone)	Degreasing	General environment	Single packing	General environment
SH-PEKMPI	PEEK (Polyetheretherketone)	Precision cleaning	Class 1,000	Degassing double packing	Class 10

[ ! ] Products are packed by order quantity. Ex. If the order is for 20 pieces, they are packed in one package (incl. 20 pieces).
[ ! ] See the

details of degreasing, precision cleaning, and electrolytic polishing shown at the bottom of the specification table.

Specifications / Overview

Nominal Diameter - Number of Teeth	Torsional Breaking Torque		Tensile Breaking Load
Nominal Diameter - Number of Teeth	(N⋅m)	(ft-lb)	(N)	(lbF)
4-40	0.19	0.140	306	68.79
6-32	0.33	0.243	459	103.18
8-32	0.61	0.450	746	167.70
10-32	0.95	0.701	1090	245.03

[ ! ] Values shown in tables are reference, and not guaranteed.

[Cautions]
·Sometimes black spots on the surface may be seen.
·The remaining gate at the tip of the screw is 5% or less of L.
· Please use in combination with a nut made of the same material as the deviation in pitch of the screw will occur during molding.
· If a nut is not used, the fitting with the tapped screw should be 20 mm or less.
·Use a torque driver and torque wrench for tightening. The recommended tightening torque is 50% of the breakage torque value in use.
· Heat and chemical resistances vary depending on the condition of use. Be sure to test the product before use under expected application conditions.
· The color may change depending on production lot and other conditions.