Flat Belt Conveyor, Center Drive, Pulley Dia. 30mm

Economical conveyor with a reasonable structure design, enabling localized production. Multiple types of models are available to meet customers' different design requirements for various usage scenarios, providing better options.
E-GVFN/E-GVFP: Full belt type. A full belt conveyor refers to a conveyor where the entire surface can be used as the transportation surface.

Feature 1: The entire conveyor surface can be used as the transportation surface.
Feature 2: The conveyor body uses an aluminum profile, achieving an overall lightweight design.
Feature 3: Light load, edge-wrapping design, suitable for customized configuration of free length and width.
Feature 4: Belt width can be specified in 5 mm units, and pulley spacing can also be specified in 5 mm units.

■ Material table

Part name	Material	Surface treatment
Profile	Aluminum	Electrophoresis
Motor cover	Aluminum	Painted baked paint
Pulley holder	Aluminum	Painted baked paint

■ Flat belt width - pulley center distance correspondence table

Model	Belt width B	Pulley center distance L
		L355 to 400	L405 to 500	L505 to 600	L605 to 800	L805 to 900	L905 to 2000
E-GVFN E-GVFP	70 to 110	●	●	●	●	●	●
	115 to 160	●	●	●	●	●	●
	165 to 210	-	-	●	●	●	●
	215 to 260	-	-	-	●	●	●
	265 to 300	-	-	-	-	-	●

(1) Do not disassemble or modify the conveyor by yourself to avoid causing performance defects.
(2) Due to differences in the operating environment of the conveyor, MISUMI conveyors do not come with a power supply, cable, or switch.
(3) Due to issues with the structural strength and deformation of the machine body, please do not exceed the allowable load or length and width when selecting a model.
(4) The motor is available in two voltage specifications: single-phase 220 V and 3-phase 220 V. Please select the voltage according to your usage requirements.
(5) Belt deviation is a normal phenomenon and does not constitute a quality problem. Deviation adjustment is part of daily maintenance.
(6) Deviation tolerance: The distance from the belt to both sides of the roller should be 5+/-3mm. During operation, it is not possible to ensure that the belt always stays at the center of the aluminum profile.     
　　For the deviation adjustment method, click here.
(7) If the direction is opposite to the standard operating direction, belt deviation, belt breakage, noise, jamming, and other abnormalities may occur. Please avoid using it in this way. (The standard transport direction is shown in the figure below)