HIT

Drawing

Product Specifications

Standard Table

Product Features Details

Advantages of use 1

• Lightweight makes it ideal for mobile air tools.
• High oil resistance compared to rubber hoses or PVC hoses, long lifespan without hardening or cracking due to oil.

Advantages of use 2

• High cold resistance allows work without hardening even in winter, improving workability.

Compliant with laws and regulations to ensure safe and secure.

• Compliant with revised RoHS2 regulations.

Improved productivity and safety with dedicated fittings.

• Various types of dedicated fittings are easy to install, prevent fluid leakage and hose disconnection for safe and secure.

Cautions/Prohibitions

1. The operating fluid used is dedicated for air. Do not use the hose for any other purpose.
　* Do not use it for fuel oil (heavy oil, light oil, kerosene, gasoline, etc.) or solvents.
2. Do not use it for drinking or food.
3. It is expected that the compounding agent, etc., may be extracted or eluted from the hose depending on the conditions of use, so check the usage conditions and the effect on the product before use.
4. Use the hose within the operating temperature range.
5. Use the hose within the working pressure range.
6. This hose should be used with a minimum bending radius or greater. If used below the minimum bending radius, the hose may bend, or the pressure resistance may decrease.
7. Do not directly touch or approach open flames.
8. When cutting the hose, make sure to cut it so that the end face is vertical. If it is not vertical, leakage or disconnection may occur.
9. Use a hose nipple suitable for the hose size. Do not use nipples with scratches or rust on their surface.
10. The use of hose fittings and hose clamps dedicated for Toyox is recommended. If you do not use the Toyox dedicated products, air may leak or the metal fittings may come off. Retighten the hose
　clamp as necessary.
　Distortion of the resin in the clamp-tightening area may cause air leakage or hose disconnection. Do not overtighten steel wire, etc., as it may cut the inner and outer surfaces of the hose and cause the hose to burst.
11. Do not use one-push metal fittings for tubes. It may cause the hose to burst.
12. The lifespan of the hose is greatly susceptible to the physical properties of the fluid, temperature, flow rate, frequency of pressurization and depressurization.
　If any of the following abnormalities or signs of abnormalities are found during pre-startup or periodic inspections, stop using the product immediately and have it repaired or replaced with a new hose.
　·Abnormality near the metal fittings: Local stretching, curvature, leaks, blisters, shallow insertion into nipples
　·Presence or absence of scratch: Large scratches and cracks on the outer surface, immersion into the reinforcement layer
　·Inner surface abnormality: Inner surface swelling and separation and wear (exposed reinforcement in the hose)
　(*) In the case of abnormalities on the inner or outer surface, the fluid may contain hose separations or fragments of reinforcement material.
　·Other significant changes (hardening, swelling, cracking, blistering, etc.)
13. Do not store it outdoors or in direct sunlight. This may cause quality deterioration such as stickiness and cracks on the hose surface.
　Store in a well-ventilated place with low humidity. Do not allow contaminants or dust to enter the hose.
14. Do not incinerate. Burning the product may damage the incinerator or produce gas harmful to the human body. Please handle it as industrial waste.
15. When disposing the product, follow the separate disposal procedures of each region.

Product Comparison Information

Dedicated fitting