Linear Slide Cylinder with Multifunctionality, LCR Series
Caution
Product Description
Contributes to tact up, miniaturization and energy savings of equipment compared to the traditional linear guide cylinder.
Contributes to increased equipment speed, compactness, and energy saving through weight reduction compared to conventional linear guide cylinders
- Pursuing lightweight design: Achieves up to 10% reduction compared to conventional models through thorough weight reduction.
- Weight reduction of moving parts enables increased equipment speed, compactness, and energy saving.
- Enhanced rigidity: Achieves increased rigidity compared to previous models (LCS) through high stiffness of the linear guide and slide table.
Rear piping port provided as standard (except for ⌀6: diameter 6 mm)
Stopper for stroke adjustment: adjustment range per side 0–5 mm
Shock absorber type stopper absorbs impact at the stroke end
Equipped with mounting holes on 2 surfaces
Normal operation
Slide table, hand, workpiece, piston rod, magnet, cylinder switch, spring
When the cushioning mechanism is operating
Buffer mechanism
Specifications
| Items | LCR | ||||||
|---|---|---|---|---|---|---|---|
| Tube inner diameter (mm) | ⌀6 | ⌀8 | ⌀12 | ⌀16 | ⌀20 | ⌀25 | |
| Operation method | Double Acting | ||||||
| Operating fluid | Compressed Air | ||||||
| Maximum operating pressure (MPa) | 0.7 | ||||||
| Minimum operating pressure (MPa) | 0.15 (*1) | ||||||
| Pressure Resistance (MPa) | 1.05 | ||||||
| Ambient temperature (℃) | -10 to +60 (no freezing) | ||||||
| Connection port diameter | Body Side | M3 | M5 | Rc 1/8 | |||
| Rear of main body | — | M3 | M5 | Rc 1/8 | |||
| Stroke tolerance (mm) | +2.0 0 (Note 2) | ||||||
| Piston Speed (mm/s) | 50 to 500 (Note 3) | ||||||
| Cushion | With Rubber Cushion | ||||||
| Lubrication | Not required (When lubrication is needed, use turbine oil class 1 ISOVG32) | ||||||
Note 1: When using a shock absorber type stopper with ⌀6, the pressure will be 0.2 MPa.
Note 2: When used without a stopper, please note that there is a slight gap between the end plate and the floating bushing.
Note 3: When using the stroke adjustment stopper, please use at 50–200 mm/s.