Small X-Axis Rack-and-Pinion Stage TAR

Small X-Axis Rack-and-Pinion Stage TAR

A small rack-and-pinion stage.

- Rack-and-pinion approach for quick feeding.
- Does not stick out of the main body, even if the stage surface is moved with a full stroke.
- The feed knob movement area plus the and the main body area equals the effective installation area.
- Dovetail grooves used for the travel guide.
- Has a mechanism for correcting rattling.
- Mounting and fixing holes are bored in both the upper and lower surfaces.
- When the stage is turned over, its lower surface can be used as a stage surface.
- Countersunk mounting screw holes.
- Can be fixed from either above or below.
- Fixing from above: M2, Fixing from below: M3/M4.
- Materials: stage: brass and black chrome plating (stage), brass and chrome plating (bottom spacer).


Part Number

Configured Part Number is shown.

Part Number
Part NumberVolume DiscountDays to ShipRoHSStroke (Range Selectable) Stroke (X Distance)
Table Straightness
Table Parallelism
32 Day(s) or more 10±30mm~±454080
32 Day(s) or more 10±30mm~±655080
32 Day(s) or more 10±10~30mm±253050


  1. 1

Basic Information

Table Size (Length) L (Range Selectable)(mm) 26~40 Table Size (Width) W (Range Selectable)(mm) ~25 Load Capacity (Range Selectable)(N) 5~30
Feeding Method Rack & Pinion Table Material Brass Table Surface Treatment Low Temperature Black Chrome Plating
Travel Guide Dovetail Slide Table Size (Thickness) H (Range Selectable)(mm) 20.1~25 Product Category Main Body
Table Size (Length) L(mm) 30 Table Size (Width) W(mm) 25 Load Capacity(N) 24.5
Table Size (Thickness) H(mm) 22 Type X-Axis Stages Feed Knob Position Holoaxial side
Clamp Clamp Lever Reversed Standard Through Hole (Table Center Hole) No
Feed method (rack & pinion type) Standard

Additional Products in this Category

Customers Who Viewed This Item Also Viewed

Tech Support

Factory Automation, Electronics, Tools, & MRO (Maintenance, Repair and Operations)
Tel:(60) 3 7960 8499 / FAX:(60) 3 7960 7499
9:00am - 6:00pm (Monday - Friday)
9:00am - 1:00pm (Saturday)