Soft Polyurethane Tubing TUS Series
Brand :
SMC
Caution
- For specifications and details, please refer to the catalog.
- Product pictures are representations.
Product Description
Extremely flexible soft polyurethane tubing.
[Features]
・ Piping in a narrow space is possible
・ Maximum operating pressure of 0.6 MPa or less (At 20°C)
Specifications Of Soft Polyurethane Tubing TUS Series
Appearance of Soft Polyurethane Tubing TUS Series (green)
Maximum operating pressure
| Nominal | TUS0425 | TUS0604 | TUS0805 | TUS1065 | TUS1208 |
|---|---|---|---|---|---|
| Outer diameter mm | 4 | 6 | 8 | 10 | 12 |
| Inner diameter (mm) | 2.5 | 4 | 5 | 6.5 | 8 |
List Of Colors
- Black (B)
- White (W)
- Red (R)
- Blue (BU)
- Yellow (Y)
- Green (G)
- Translucent (N) Note 1)
- Yellow brown (YB)
Specifications
| Fluid | Air | |||||
|---|---|---|---|---|---|---|
| Maximum operating pressure MPa | 20°C | 0.6 | ||||
| 40°C | 0.6 | |||||
| 60°C | 0.4 | |||||
| Applicable fittings | Note 3) One-touch fitting, insert fitting, miniature fitting (Hose-nipple type) | |||||
| Note 2) Minimum bending radius mm | 8 | 15 | 15 | 22 | 29 | |
| Operating temperature | -20 to +60°C (No freezing) | |||||
| Material | Polyurethane | |||||
| Tube drawing strength N (using one-touch fitting) | Without inner sleeve | 15 | 60 | 60 | 85 | 110 |
| With inner sleeve | 80 | 230 | 250 | 300 | 480 | |
Note 1) Not clear, but translucent due to material.
Note 2) The minimum bending radius is measured as shown in the figure below.
Note 3) Always use an inner sleeve (TJ series) in safety circuits or critical areas.
How to measure the minimum bending radius
Bend the tube into a U shape at a temperature of 20°C. Fix one end and close the loop gradually. Measure 2R when the tube breaks or is crushed.
Caution
- 1. Use nylon or polyurethane tubing for general industrial water, otherwise the tube may fall out or burst when the maximum operating pressure is low and surge pressure occurs.
- 2. Abnormal temperature rise caused by adiabatic compression may result in the tube bursting.
- 3. The value of the minimum bending radius is measured at a temperature of 20°C as shown in the figure above ("How to measure the minimum bending radius").
- 4. Use an inner sleeve, taking the removing force into consideration when using with one-touch fittings.
* See the manufacturer's catalog for safety information.