1.27‑mm Pitch Two-Piece Connectors, HIF6 Series

Brand :

HIROSE ELECTRIC

Caution

Product Description

Board-to-board and board-to-cable connection variations available. Uses a flat-type cable with 1.27-mm pitch, so it can be used with each type of connector.

[Features]
・Product variation: connection methods include board-to-board model and cable pressure connection.
・Wide range of use: using flat-type cable with 1.27-mm pitch, it can be used with HIF2E, HIF3B, HIF5, etc.
・Compatible cables: AWG#28 flat cable (7/0.127 mm, outer diameter 0.8 - 1.0 mm).
・Construction that prevents mis-insertion: mis-insertion prevention guide prevents accidental insertion.

1.27‑mm Pitch Two-Piece Connectors

HIF6 Series list

Features of HIF6 Series 1.27‑mm Pitch Two-Piece Connectors

Product Standards

Rating	Rated current: 0.5 A Rated voltage: 125 V AC	Operating temperature range: -55 to +85°C (Note 1) Operating humidity range: 40 to 80%	Storage temperature range -10 to +60°C (Note 2) Storage humidity range 40 to 70% (Note 2)

Item	Standard	Conditions
1. Insulation resistance	1,000 MΩ or more	Measure at 250 V DC
2. Withstand voltage	There shall be no flashover or dielectric breakdown.	Energize at 300 V AC rms for 1 min
3. Contact resistance	30 mΩ or less	Measure at 0.1 A
4. Vibration resistance	There shall be no electrical discontinuity for 1 μs or greater.	10 to 55 Hz, Single amplitude: 0.75 mm, Three directions, 2 hours
5. Humidity resistance	Insulation resistance: 1,000 MΩ or more	Leave at temperature 40°C ±2°C and humidity 90 to 95% for 96 hours
6. Temperature cycle	There shall be no cracking or abnormalities with any of the parts.	(-65°C: 30 mins. > 15 to 35°C: Max. 5 mins. > 125°C: 30 mins. > 15 to 35°C: Max. 5 mins.) 5 cycles
7. Durability (mating / un-mating)	Contact resistance: 30 mΩ or less	500 times
8. Solder heat resistance	No melting of resin parts affecting performance.	Solder bath: 260°C for 10 seconds
8. Solder heat resistance	No melting of resin parts affecting performance.	Manual solder: Soldering iron temperature of 360°C for 5 seconds

(Note 1) This includes temperature increases caused by the flow of current.
(Note 2) The term "storage" refers to products stored for long periods of time prior to mounting and use. The operating temperature range and humidity range covers non-conducting condition of installed connectors in storage, shipment or during transportation.
(Note 3) Be aware that lock deformation may occur if an excessive load is placed on the inside of the lock.