Flat Belt Conveyor, Center Drive, Pulley Dia. 50mm

Economical conveyor with a reasonable structure design, enabling localized production. A variety of models are available to meet customers' design requirements for different usage scenarios, providing better selection options.
E-CVGR/E-CVGW: Flat belt conveyors with adjustable driving part positions allow belt tension adjustment within the central driving part without changing the overall length, and various accessories can also be added to both sides of the machine body.

Feature 1: Simplifies the belt replacement step, improving maintenance.
Feature 2: The conveyor body uses an aluminum profile, achieving an overall lightweight design.
Feature 3: Belt width can be specified in 5 mm units, and pulley distance can also be specified in 5 mm units.

■ Material table

Part name	Material	Surface treatment
Profile	Aluminum	Electrophoresis
Motor cover	Aluminum	Painted baked paint
Pulley holder	Aluminum	Painted baked paint

■ Flat belt width - pulley center distance correspondence table

Model	Belt width B	Pulley center distance L
		L385 to 500	L505 to 600	L605 to 700	L705 to 800	L805 to 900	L905 to 3000
E-CVGR E-CVGW	50 to 110	●	●	●	●	●	●
	115 to 160	●	●	●	●	●	●
	165 to 210	-	●	●	●	●	●
	215 to 260	-	-	●	●	●	●
	265 to 400	-	-	-	●	●	●

(1) Do not disassemble or modify the conveyor by yourself to avoid causing performance defects.
(2) Due to differences in the operating environment of the conveyor, MISUMI conveyors do not come with a power supply, cable, or switch.
(3) Due to issues with the structural strength and deformation of the machine body, please do not exceed the allowable load or length and width when selecting a model.
(4) The motor is available in two voltage specifications: single-phase 220 V and 3-phase 220 V. Please select the voltage according to your usage requirements.
(5) Belt deviation is a normal phenomenon and does not constitute a quality problem. Deviation adjustment is part of daily maintenance.     Click here.
(6) Deviation tolerance: The distance from the belt to both sides of the roller should be 5+/-3mm. During operation, it is not possible to ensure that the belt always stays at the center of the aluminum profile.
(7) If the direction is opposite to the standard operating direction, belt deviation, belt breakage, noise, jamming, and other abnormalities may occur. Please avoid using it in this way. (The standard transport direction is shown in the figure below)